Instruments & Meters

Instron ties better crash simulation to high strain rate material data

The testing machine maker argues that rate-dependent material data, not more data, is what sharpens simulation, material choice and early design work.

Petra DahlbergOctober 25, 20265 min read4 views
A concept illustration of a high strain rate test rig holding a speckle-patterned composite specimen, with an abstract crash-structure simulation alongside it.

Material data recorded under slow, quasi-static loading may not represent how a component behaves in a crash. In an article attributed to Andrea Incardona, an application engineer and product specialist at high strain rate testing machine manufacturer Instron, the company sets out how dynamic characterisation is intended to feed simulation, material selection and product development.

The starting point is strain-rate dependence: many materials change their mechanical response as loading speed rises, so a material characterised quasi-statically can respond differently under rapid impact or a crash event.

A study puts numbers on the mismatch

Instron cites a 2025 study in the SAE International Journal of Materials and Manufacturing, ‘Influence of Strain Rate Effect on Mechanical and Crashworthiness Properties of CFRP Composite Structures’. According to the article, incorporating strain-rate-dependent properties into crash simulations of carbon-fibre-reinforced composite structures reduced the discrepancy between simulated and experimental results: peak acceleration by 6.5 per cent, mean acceleration by 5.9 per cent and displacement by 6.3 per cent.

The company frames that as an argument about relevance rather than volume, noting that material data is only useful to the extent that it matches the conditions a part will face.

Range and timing of the tests

According to Instron, characterisation can run from quasi-static conditions up to strain rates approaching 1,000/s, with the achievable range set by the material, the specimen geometry and the test method. Individual tests can last only 3 to 10 milliseconds, which throws the burden onto data acquisition.

  • Instron says its high strain rate systems support data acquisition at up to 200 kHz.
  • Digital image correlation (DIC) is presented as a way to add information on strain development across the specimen.
  • Analysis tools are described as supporting data processing and theoretical modelling.

The article adds that if strength, stiffness, deformation mechanisms or failure behaviour shift with strain rate, a model built only on conventional data may fail to represent a rapid event.

Selection and development

Beyond simulation, Instron argues that two materials which look comparable in conventional strength and stiffness testing can diverge under high strain rate loading. That matters where weight has to be traded against energy absorption, with automotive crash structures and aerospace components given as examples. Because the data can be generated earlier, the company positions testing as an input to design decisions and physical validation rather than a final check on a finished design.

All figures and capability limits described in the article come from Instron or the study it cites; no independent verification is reported.