SinceVision has introduced the SGI-N030W, a wide-spot laser displacement sensor designed for high-speed, non-contact dimensional measurement on rough, textured and irregular surfaces. The sensor extends the company’s SGI Series and uses an expanded laser spot with optical triangulation. SinceVision says the design is intended to address measurement instability that conventional point-spot laser systems can encounter when surface finishes vary.
In a point-spot configuration, reflected laser energy is concentrated on a small area, so microscopic scratches, grain boundaries, brushed textures and matte finishes can create signal variations. Those variations may be interpreted as dimensional changes, producing false defect warnings and requiring additional inspection. The SGI-N030W instead collects reflected light across a broader area and averages localised microscopic peaks and valleys before signal conversion. SinceVision says this reduces the influence of surface roughness and optical scattering on materials such as drawn metals, sandblasted surfaces and coated battery foils.
Specified performance and interfaces
The sensor has a 30 mm reference distance and a ±5 mm measurement range. SinceVision specifies repeatability of 0.05 µm on a diffuse white target under static conditions and linearity of ±0.02% of full scale across the range. A 50 kHz sampling frequency, equivalent to a 20 µs update interval, is intended to support high-speed measurement and monitoring of dynamic processes. Communication options include RS485, 100Base-TX Ethernet and switchable analogue outputs for 4–20 mA current or 0–10 V voltage signals. Master-slave synchronisation allows two sensors to operate in opposition, measuring from either side of a component or moving material.
Battery electrode inspection
One principal application identified by SinceVision is in-line thickness measurement of lithium-ion battery electrodes, where coating thickness and uniformity affect energy density, internal resistance and long-term cell stability. The company notes that offline inspection with contact micrometers or drop indicators can introduce operator variability and may deform wet or uncured electrode materials, while periodic spot measurements cannot provide continuous coverage across a production reel.
The proposed arrangement uses two synchronised sensors above and below a moving electrode web. Mounted on a calibrated, low-thermal-expansion marble gantry, the opposing heads measure their respective clearances to the material. A system controller combines those readings with the fixed mounting datum to calculate absolute electrode thickness in real time. According to SinceVision, production trials demonstrated stable, repeatable thickness measurement within ±0.3 µm at a web speed of 300 mm/s. The company says the 50 kHz sampling rate provides longitudinal resolution for detecting localised coating agglomerations, edge thinning and exposed substrate before the electrode proceeds to cell winding.
Semiconductor and precision-assembly applications
SinceVision also intends the sensor for semiconductor manufacturing, where non-contact measurement is important for sensitive wafer surfaces. Potential uses include wafer position verification, edge detection, height measurement and checks of wafer seating and chuck alignment in atmospheric transfer modules and vacuum load-lock systems. In precision assembly, the sensor can monitor voice coil motors, linear actuators and micro-steppers. At 50 kHz, it is intended to capture transient displacement, mechanical oscillations, settling behaviour and end-stop overshoot across the full measurement range. Position data can be sent to machine control systems over Ethernet for real-time monitoring and process control.
Addressing surface-related errors
Jack Li, Global Sales and Marketing Director at SinceVision, says false defect warnings caused by surface texture remain a recurring challenge in battery manufacturing and precision assembly. He explains that conventional point-beam laser sensors can interpret microscopic scratches and rough coatings as actual thickness variations, slowing production lines and creating a need for additional manual inspection. According to Li, the SGI-N030W’s expanded optical spot is designed to average out those surface-related variations, while synchronisation between opposing sensor heads supports high-speed thickness verification.
