Chevrolet launched the mid-engine Corvette C8 with a dual-clutch automatic as its only transmission, but a manual version does exist as a one-off development car built around a Tremec gearbox. Tremec invited a journalist and several potential customers to sample its transmissions at Motorsports Gateway, a private track outside Howell, Michigan. The journalist drove the Peitz Performance C8 race car fitted with Tremec's new manual transaxle.
The vehicle was a Peitz Performance C8 race car with a full roll cage and harness, essentially no interior finish, and a shifter mounted where the production car's storage cubby and automatic selector normally sit. The car is a one-off.
The context helps explain the project. The C8 was the first Corvette with its engine behind the driver and the first offered only with a dual-clutch automatic. Chevrolet had spent decades developing front-engine cars, and engineering two new transaxles for the mid-engine layout—one manual, one automatic—would have added cost and complexity. The production car's automatic-only strategy helped it compete in comparison tests, but it left enthusiasts without a factory manual.
Installation and driving feel
Peitz did not need major structural changes beyond cutting the tunnel to install clutch-pedal hardware. The manual gearbox occupies the same space as the stock dual-clutch unit, and the installation did not require elaborate mating hardware. The C8's pedal box has enough room for a clutch pedal; even with three pedals, the footwell felt roomier than a previous-generation Camaro's.
The shifter is remotely mounted and linked by cables to the rear transaxle, unlike the direct mechanical connection in front-engine cars using Tremec's TR-6060 six-speed. That layout makes the C8 manual less precise and less mechanical-feeling than its front-engine counterpart, and also less notchy. Tremec's setup may smooth some rough edges, but it also loses some of the direct feel. Fixing that would require moving the engine forward or the shifter rearward, neither of which is practical in the C8 layout.
The test car's seating position was not adjustable, and the 5-foot-7-inch driver could not reach the floor or brace properly in corners, making heel-and-toe downshifts awkward. The track was also new and green on a November afternoon in Michigan, so the drive was not a full performance evaluation.
Cost and outlook
The biggest obstacle is cost. The Tremec gearbox alone is priced at about $75,000, and combining that with a Corvette donor car puts a manual C8 build near the price of a showroom-spec Z06. Tremec said the price should fall as volume rises. It also said automakers are interested, not necessarily or exclusively General Motors; other manufacturers are seeking a high-torque manual transaxle, though no customers were named.
The car demonstrates that a manual transaxle can fit the C8 without a fundamental redesign, but it does not mean Chevrolet will offer one. The project is a development vehicle, not a production option. For enthusiasts, it shows both the appeal of a third pedal in America's sports car and the engineering and business barriers that kept the production C8 automatic-only.
