Industrial Machinery

WITT Gas Controls to Bring MEM+ Gas Mixers and ULTRA Safety Valves to FABTECH 2026

The gas safety and control supplier will use Booth S46114 at the Las Vegas show to discuss mixing accuracy, pressure regulation and backflow protection.

Mateo AlvarezOctober 25, 20265 min read7 views
A stainless steel gas mixing cabinet with proportional valves, regulators and a manifold blending separate gas streams into one flow, shown in an industrial workshop setting.

WITT Gas Controls will exhibit at FABTECH 2026, held October 21–23 at the Las Vegas Convention Center in Las Vegas, Nevada, and has invited attendees to Booth S46114 to discuss its gas mixing, pressure regulation and safety valve equipment.

The company, which describes itself as a global supplier of gas safety, control and analysis solutions, will center its booth program on the MEM+ gas mixer series, its dome pressure regulators and its gas safety valves. WITT frames the three product lines around what it identifies as core requirements in industrial gas handling: precise mixing, stable pressure and system protection.

MEM+ mixers emphasize speed and repeatability

The MEM+ series is built to blend two or three non-flammable gases — nitrogen, carbon dioxide or oxygen among them — for a range of industrial applications. Operation is electronic: motorized proportional valves adjust in 0.1 percent increments, and WITT states that a target mixture can be reached in less than three seconds with accuracy better than ±1% absolute.

Seven interface options, including Ethernet, OPC UA and PROFINET, allow the mixers to be integrated into existing systems. Users can operate them remotely through a PC, PLC or machine controller, or locally through a touchscreen interface.

For stable running, the units use pressure equalization to compensate for supply pressure fluctuations, continuous inlet pressure monitoring with pressure alarms, and an integrated buffer tank to accommodate fluctuating flow rates. The series is housed in a splash-proof brushed stainless steel enclosure and is rated for maximum inlet pressures of 20 bar and maximum outlet pressures of 10 bar.

Dome regulators and ULTRA valves round out the display

WITT will also highlight its dome pressure regulators, which rely on optimized pilot pressure regulators to hold working pressure steady as flow rates and inlet pressures change. The design is intended to support consistent process performance and product quality, and WITT notes that the improvements can be retrofitted to existing dome pressure regulators without replacing the complete system.

The ULTRA non-return valves and ULTRAVENT safety relief valves complete the lineup. ULTRA non-return valves combine low opening pressures, tight sealing and minimal flow resistance to protect gas systems against unwanted backflow, while ULTRAVENT relief valves guard against excessive pressure and respond to pressure increases as low as 5 mbar.

At Booth S46114, WITT representatives will be available to discuss how the mixers, regulators and valves apply to specific gas handling requirements.